Changed the ECM Giotto's Filter Gasket
I couldn't take it anymore. The ECM Giotto at home has been dripping from the around the portafilter for the past little while. The reason being that the filter gasket was old, hard, and cracked.
So, I pick up a new gasket on the way to the office. This sets me about around $13. This is the easy part.
When I get home to attempt the repair, I find that the old gasket doesn't want to come out.
The instructions that I found on the web are straight forward and shold work for all E61 group head machines:
- Remove the drip tray
- Take a flat screw driver and lever against the inside of the group head and the outside of the shower filter. The shower filter and gasket will drop out. (yeah, right)
- To re-instate the filter and new gasket. Insert the shower into the new gasket ensuring the flat side of the gasket is facing down.
- Take the portafilter and remove the coffee filter. Place the gasket and shower set in the portafilter and load into the group by applying upward pressure and turning, as if loading into the machine normally. Turn the portafilter around so it goes beyond the right angle position. (yeah right, again....)
What you REALLY need to do:
What you really need to do, if the gasket is hard, is to chip out the old one with a small chisel. Once it cracks and a fair sized piece falls out, use a flat screwdriver to pry out the rest of the old cracked bits of rubber until the rest of the gasket is removed.
If you try to do a brute force prying of the shower filter, I'm pretty sure the screw driver will puncture and damange the shower filter.
To replace the gasket, you need to put a tiny bit of dish soap or food grade lubricant on the outside of the gasket to lube it. Next, fit the gasket back into the groove by prying lightly with a flat head screwdriver so that it is seated all the way around. THEN, use the empty portafilter and use it to press the gasket back into the machine.
So, I pick up a new gasket on the way to the office. This sets me about around $13. This is the easy part.
When I get home to attempt the repair, I find that the old gasket doesn't want to come out.
The instructions that I found on the web are straight forward and shold work for all E61 group head machines:
- Remove the drip tray
- Take a flat screw driver and lever against the inside of the group head and the outside of the shower filter. The shower filter and gasket will drop out. (yeah, right)
- To re-instate the filter and new gasket. Insert the shower into the new gasket ensuring the flat side of the gasket is facing down.
- Take the portafilter and remove the coffee filter. Place the gasket and shower set in the portafilter and load into the group by applying upward pressure and turning, as if loading into the machine normally. Turn the portafilter around so it goes beyond the right angle position. (yeah right, again....)
What you REALLY need to do:
What you really need to do, if the gasket is hard, is to chip out the old one with a small chisel. Once it cracks and a fair sized piece falls out, use a flat screwdriver to pry out the rest of the old cracked bits of rubber until the rest of the gasket is removed.
If you try to do a brute force prying of the shower filter, I'm pretty sure the screw driver will puncture and damange the shower filter.
To replace the gasket, you need to put a tiny bit of dish soap or food grade lubricant on the outside of the gasket to lube it. Next, fit the gasket back into the groove by prying lightly with a flat head screwdriver so that it is seated all the way around. THEN, use the empty portafilter and use it to press the gasket back into the machine.
posted by Renart at
7:33 PM
|
2 comments
